HEADLAMP — Installation/Adjustment (Cont'd) + Headlamp Motor Check + Bulb Replacement
EL-45prose procedureMotor continuity matrix uses ① / ② / ③ / ④ / ⑤ pin numbers (transcribed as 1/2/3/4/5).
Installation and Adjustment (Cont'd)
Stopper adjustment
- 1Adjust stopper.
- 2Loosen lock nut on stopper.
- 3Turn motor manual knob to open headlamp assembly completely.
- 4Adjust stopper screw.
Headlamp Motor Check
Headlamp motor — circuit continuity test
- 1Disconnect battery ground cable.
- 2Disconnect the headlamp motor connector.
- 3Use an ohmmeter to check for continuity in headlamp motor circuit while rotating motor with manual knob.
Headlamp motor — link-position vs continuity
CLOSE
Ohmmeter (+) probe1
Ohmmeter (−) probe5
ContinuityYES
CLOSE
Ohmmeter (+) probe2
Ohmmeter (−) probe5
ContinuityNO
CLOSE
Ohmmeter (+) probe1
Ohmmeter (−) probe3
ContinuityNO
CLOSE
Ohmmeter (+) probe3
Ohmmeter (−) probe1
ContinuityYES
OPEN
Ohmmeter (+) probe1
Ohmmeter (−) probe5
ContinuityNO
OPEN
Ohmmeter (+) probe2
Ohmmeter (−) probe5
ContinuityYES
OPEN
Ohmmeter (+) probe3
Ohmmeter (−) probe4
ContinuityNO
OPEN
Ohmmeter (+) probe4
Ohmmeter (−) probe2
ContinuityYES
Bulb Replacement
INSTALLING HEADLAMP RUBBER CAP
Headlamp rubber-cap installation
- 1When installing the rubber cap, set the "TOP" or "▲" mark so that it is facing up.
- 2Press the rubber cap firmly so that the lip makes contact with the headlamp body.