STARTING SYSTEM — Starter — Assembly (Cont'd) / Service Data and Specifications
EL-24spec tableAssembly (Cont'd)
PINION PROTRUSION LENGTH ADJUSTMENT
With pinion driven out by magnetic switch, push pinion back to remove slack and measure clearance "ℓ" between the front edge of the pinion and the pinion stopper.
| Specification | Value |
|---|---|
| Clearance "ℓ" | Refer to S.D.S. |
Clearance "ℓ"
Refer to S.D.S.
NOTE
Not in the specified value ... Adjust by adjusting plate.
Service Data and Specifications (S.D.S.)
STARTER
Starter Specifications
Type
Unit
S114-523HITACHI make
M1T71481MITSUBISHI make
Gear type
Unit
S114-523Reduction gear type
M1T71481Reduction gear type
Applied model
Unit
S114-523All
M1T71481All
System voltage
UnitV
S114-52312
M1T7148112
No-load Terminal voltage
UnitV
S114-52311.0
M1T7148111.0
No-load Current
UnitA
S114-523Less than 90
M1T7148150 - 75
No-load Revolution
Unitrpm
S114-523More than 2,950
M1T714813,000 - 4,000
Minimum diameter of commutator
Unitmm (in)
S114-52332.0 (1.260)
M1T7148128.8 (1.134)
Minimum length of brush
Unitmm (in)
S114-52311.0 (0.433)
M1T7148112.0 (0.472)
Brush spring tension
UnitN (kg, lb)
S114-52317.7 - 21.6 (1.8 - 2.2, 4.0 - 4.9)
M1T7148113.7 - 25.5 (1.4 - 2.6, 3.1 - 5.7)
Clearance of bearing metal and armature shaft
Unitmm (in)
S114-5230.2 (0.008)
M1T71481—
Clearance "ℓ" between pinion front edge and pinion stopper
Unitmm (in)
S114-5230.3 - 1.5 (0.012 - 0.059)
M1T714810.5 - 2.0 (0.020 - 0.079)
See also
S.D.S.