CHARGING SYSTEM — Alternator — Assembly
EL-30prose procedureAssembly
WARNING
Carefully observe the following instructions. When soldering each stator coil lead wire to diode assembly terminal, carry out the operation as fast as possible.
WHEN SOLDERING BRUSH LEAD WIRE
Brush lead-wire soldering position
- 1Position brush so that its wear limit line protrudes 2 mm (0.08 in) beyond end face of brush holder.
RING FITTING IN REAR BEARING
Rear-bearing retaining-ring fitment
- 1Fix ring into groove in rear bearing so that it is as close to the adjacent area as possible.
REAR COVER INSTALLATION
Rear cover installation — brush-lift wire handling
- 1Before installing front cover with pulley and rotor with rear cover, push brush up with fingers and retain brush by inserting brush lift wire into brush lift hole from outside.
- 2After installing front and rear sides of alternator, pull brush lift wire by pushing toward the center.
WARNING
Do not pull brush lift wire by pushing toward outside of rear cover as it will damage slip ring sliding surface.