PRECAUTIONS AND PREPARATION
RA-2prose procedurePrecautions
When installing each rubber part, final tightening must be carried out under unladen condition* with tires on ground.
* Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools, and mats in designated positions.
Use Tool when removing or installing brake tubes.
When removing each suspension part, check wheel alignment and adjust if necessary.
Do not jack up at the lower arm.
Preparation
SPECIAL SERVICE TOOLS
NOTE
*: Special tool or commercial equivalent
Special Service Tools
HT71780000*
Tool nameSpring compressor
DescriptionRemoving and installing coil spring
ST35652000*
Tool nameStrut attachment
DescriptionFixing strut assembly
GG94310000*
Tool nameFlare nut torque wrench
DescriptionRemoving and installing brake piping
ST30031000*
Tool nameBearing puller
DescriptionRemoving inner race of wheel bearing
ST38280000
Tool nameArm bushing remover
DescriptionRemoving and installing bushing of rear axle housing