WINDSHIELD AND WINDOWS — Back Door Window
BF-30parts diagramBack Door Window
Construction and removal/reinstallation method of back door window are basically the same as those of windshield.
IMPORTANT
Major differences are that sealant & dam rubber are installed to back door panel instead of glass surface. Spacer position is also changed. Moreover, there are locating pins in lower portion of glass. For details, refer to following figure.
For sealant drying period, refer to "Drying Time for Sealant".
For details of moldings, refer to "Exterior".
When installing molding fastener, heat body panel and fastener to approximately 30 to 40 °C (86 to 104 °F).
| Specification | Value |
|---|---|
| Sealant bead height (back-door window) | More than 12mm (0.47 in) |
| Sealant bead base width (back-door window) | More than 7mm (0.28 in) |
| Heat-fastener install temperatureWhen installing molding fastener. | 30 - 40°C (86 - 104 °F) |
Sealant bead height (back-door window)
More than 12mm (0.47 in)
Sealant bead base width (back-door window)
More than 7mm (0.28 in)
Heat-fastener install temperatureWhen installing molding fastener.
30 - 40°C (86 - 104 °F)